Site-Specific Safety Plan for subcontractors in Iowa.
Most safety directors in Des Moines can tell a template from a plan in the first page. This Site-Specific Safety Plan is built from your scope, your hazards, and your people.
What GCs in Iowa check for
The GC's safety director checks it against the subcontract's safety exhibit before you can badge in: named competent persons with a basis, hazards matched to your scope, an emergency plan with the nearest hospital, a training and orientation section, and a signature page. A corporate manual does not pass; it has to name this project.
In Iowa, Iowa OSHA is the enforcing agency. Where the state has its own requirement on this subject, the plan carries a Iowa section that says so.
- Iowa OSHA enforces the state program, which adopts federal 1926 with Iowa additions.
The structure follows ANSI A10.33 project structure, OSHA 1926 subparts by hazard, and the USACE A-02 reviewer checklist, so the sections a reviewer expects are in the order they expect them.
The sample pages on this site are for a fictional electrical sub; your plan reads the same way with your project, your GC, and your crew.
What’s inside
- 1.Project information
- 2.Responsibilities
- 3.Competent persons
- 4.Hazard analysis by task
- 5.Fall protection
- 6.Electrical safety / LOTO
- 7.Silica and dust
- 8.Emergency action plan
- 9.Training and toolbox talks
- 10.Signatures
$199, ready in about two minutes after you answer, with your logo on every page.
Questions from Iowa subs
- What do GCs in Iowa ask for in a site-specific safety plan?
- The same core elements across Des Moines and Cedar Rapids: scope of work, a hazard analysis by task, controls for each hazard, named competent persons, an emergency plan with the nearest hospital, training and orientation, incident reporting, and a signed acceptance page. Iowa OSHA enforces the state program, which adopts federal 1926 with Iowa additions.
- Is a corporate safety manual enough?
- Usually not. Subcontract safety exhibits ask for a plan written for this project: the project name, the GC, the scope, the site's hazards, and the people on this crew. That is what the plan generates.
- Does a site-specific safety plan have to be state-specific in Iowa?
- Iowa runs its own state plan, enforced by Iowa OSHA, so the plan follows federal 1926 plus the state's additions. Your plan is written for the project address, and where Iowa has its own rule on the subject the plan says so and applies the stricter requirement.
- Is this OSHA-approved?
- No document is. OSHA and the state programs do not approve written plans; they inspect against them. This plan is prepared from your answers, says so on page one, and you adopt and implement it. That is what a GC's safety director is checking for.
- How long does it take?
- About 15 minutes of questions on your phone, then the documents generate in under two minutes. Word and PDF, English and Spanish, with your logo on the cover.
- What if the GC asks for changes?
- Edit your answers and regenerate as often as you like for 30 days at no charge. Every version stays downloadable. If it is not what you needed, reply to any of our emails within 30 days for a full refund.