Fall Protection Plan for roofing, framing, and steel contractors in Iowa.
A GC in Des Moines wants a Fall Protection Plan that names this project, this crew, and this scope. That is what you get here, in Word and PDF, English and Spanish.
What GCs in Iowa check for
GCs on roofing, framing, steel, and precast scopes want to see which systems you use where, who the competent person is, how a suspended worker gets down, and the training record. If you plan to use warning lines or a safety monitor, they want the 502(k) reasoning in writing.
Iowa OSHA enforces construction safety for private employers in Iowa; the plan says which rules apply and applies the stricter one where the state adds to federal OSHA.
- Iowa OSHA enforces the state program, which adopts federal 1926 with Iowa additions.
Reviewers check for named people with a basis, hazards matched to scope, and a signature page. All three are built in, written to 29 CFR 1926 Subpart M (.500 to .503).
Competent persons, the nearest hospital, the muster point, and the emergency chain are all in it, because those are the lines a reviewer checks first.
What’s inside
- 1.Purpose and scope
- 2.Qualified and competent persons
- 3.Fall hazards identified for this project
- 4.Fall protection systems in use
- 5.Anchor points and equipment inspection
- 6.Infeasibility narrative (1926.502(k)), when selected
- 7.Rescue plan
- 8.Training
- 9.Signatures
One payment of $149. Edit your answers and regenerate as often as you need for 30 days.
Questions from Iowa roofing and framing subs
- What is the fall protection trigger height in Iowa?
- Federal OSHA requires fall protection at 6 feet above a lower level in construction, and Iowa follows that baseline. Your GC may require more, and the plan applies the stricter requirement.
- Do I need a qualified person?
- Only for engineered anchorages, horizontal lifelines, or a fall protection plan under 1926.502(k) where guardrails, nets, and harnesses are infeasible. The wizard asks; if you name one, the plan includes the signed 502(k) section.
- Does a fall protection plan have to be state-specific in Iowa?
- Iowa runs its own state plan, enforced by Iowa OSHA, so the plan follows federal 1926 plus the state's additions. Your plan is written for the project address, and where Iowa has its own rule on the subject the plan says so and applies the stricter requirement.
- Is this OSHA-approved?
- No document is. OSHA and the state programs do not approve written plans; they inspect against them. This plan is prepared from your answers, says so on page one, and you adopt and implement it. That is what a GC's safety director is checking for.
- How long does it take?
- About 15 minutes of questions on your phone, then the documents generate in under two minutes. Word and PDF, English and Spanish, with your logo on the cover.
- What if the GC asks for changes?
- Edit your answers and regenerate as often as you like for 30 days at no charge. Every version stays downloadable. If it is not what you needed, reply to any of our emails within 30 days for a full refund.