Hazard Communication Program for every trade in Iowa.
A GC in Des Moines wants a Hazard Communication Program that names this project, this crew, and this scope. That is what you get here, in Word and PDF, English and Spanish.
What GCs in Iowa check for
It is on every GC checklist and is often the first thing an ISNetworld or Avetta audit asks for. The reviewer looks for a product inventory for this project, where the SDS binder is, who administers the program, and the training section.
In Iowa, Iowa OSHA is the enforcing agency. Where the state has its own requirement on this subject, the plan carries a Iowa section that says so.
- Iowa OSHA enforces the state program, which adopts federal 1926 with Iowa additions.
Reviewers check for named people with a basis, hazards matched to scope, and a signature page. All three are built in, written to 29 CFR 1910.1200(e) as applied to construction by 1926.59.
Competent persons, the nearest hospital, the muster point, and the emergency chain are all in it, because those are the lines a reviewer checks first.
What’s inside
- 1.Purpose and scope
- 2.Chemical inventory
- 3.Labels and other forms of warning
- 4.Safety Data Sheets and where they are
- 5.Training
- 6.Non-routine tasks
- 7.Multi-employer worksites
- 8.Signatures
$149, ready in about two minutes after you answer, with your logo on every page.
Questions from Iowa every sub
- Is a HazCom program required for a small subcontractor in Iowa?
- Yes, for any employer whose workers use or are exposed to hazardous chemicals, which includes adhesives, solvents, fuels, and cement products. Iowa runs its own state plan, enforced by Iowa OSHA, so the plan follows federal 1926 plus the state's additions.
- Do I need an SDS for every product?
- Yes, for every hazardous product you bring to the site, on site and reachable during the shift. The wizard pre-fills the usual products for your trade; you add yours and say where the binder is.
- Does a hazard communication program have to be state-specific in Iowa?
- Iowa runs its own state plan, enforced by Iowa OSHA, so the plan follows federal 1926 plus the state's additions. Your plan is written for the project address, and where Iowa has its own rule on the subject the plan says so and applies the stricter requirement.
- Is this OSHA-approved?
- No document is. OSHA and the state programs do not approve written plans; they inspect against them. This plan is prepared from your answers, says so on page one, and you adopt and implement it. That is what a GC's safety director is checking for.
- How long does it take?
- About 15 minutes of questions on your phone, then the documents generate in under two minutes. Word and PDF, English and Spanish, with your logo on the cover.
- What if the GC asks for changes?
- Edit your answers and regenerate as often as you like for 30 days at no charge. Every version stays downloadable. If it is not what you needed, reply to any of our emails within 30 days for a full refund.