Hazard Communication Program for every trade in Texas.
Pre-mob paperwork due and the Hazard Communication Program is the one holding up the badge? Answer ten questions and it is written for the project, not copied from a template.
What GCs in Texas check for
It is on every GC checklist and is often the first thing an ISNetworld or Avetta audit asks for. The reviewer looks for a product inventory for this project, where the SDS binder is, who administers the program, and the training section.
Texas GCs, especially in Houston, review subcontractor plans before badging. The plan is built to pass that review the first time.
- Federal OSHA standards apply to private construction; the state preempted local rest-break ordinances in 2023.
- Heat is the first thing a Texas GC's safety director asks about between May and September.
Nothing in it is boilerplate you have to hunt through: the hazards come from your tasks and equipment, the controls from a library written to 29 CFR 1910.1200(e) as applied to construction by 1926.59.
Nothing here is OSHA-approved, because nothing is. What you get is a plan that names the right people, matches the scope, and is signed by you.
What’s inside
- 1.Purpose and scope
- 2.Chemical inventory
- 3.Labels and other forms of warning
- 4.Safety Data Sheets and where they are
- 5.Training
- 6.Non-routine tasks
- 7.Multi-employer worksites
- 8.Signatures
$149 for the document, with free edits and regeneration for 30 days and a full refund if the GC rejects it.
Questions from Texas every sub
- Is a HazCom program required for a small subcontractor in Texas?
- Yes, for any employer whose workers use or are exposed to hazardous chemicals, which includes adhesives, solvents, fuels, and cement products. Private construction in Texas is covered by federal OSHA (Federal OSHA (Austin, Corpus Christi, Dallas, El Paso, Fort Worth, Houston, Lubbock, and San Antonio area offices)).
- Do I need an SDS for every product?
- Yes, for every hazardous product you bring to the site, on site and reachable during the shift. The wizard pre-fills the usual products for your trade; you add yours and say where the binder is.
- Does a hazard communication program have to be state-specific in Texas?
- Private construction in Texas is covered by federal OSHA (Federal OSHA (Austin, Corpus Christi, Dallas, El Paso, Fort Worth, Houston, Lubbock, and San Antonio area offices)). Your plan is written for the project address, and where Texas has its own rule on the subject the plan says so and applies the stricter requirement.
- Is this OSHA-approved?
- No document is. OSHA and the state programs do not approve written plans; they inspect against them. This plan is prepared from your answers, says so on page one, and you adopt and implement it. That is what a GC's safety director is checking for.
- How long does it take?
- About 15 minutes of questions on your phone, then the documents generate in under two minutes. Word and PDF, English and Spanish, with your logo on the cover.
- What if the GC asks for changes?
- Edit your answers and regenerate as often as you like for 30 days at no charge. Every version stays downloadable. If it is not what you needed, reply to any of our emails within 30 days for a full refund.