Safety plans written for Texas projects.
Federal OSHA (Austin, Corpus Christi, Dallas, El Paso, Fort Worth, Houston, Lubbock, and San Antonio area offices) enforces construction safety for private employers in Texas. Each document below is prepared from your answers for the project address, with the state's own rules applied where they add to federal OSHA.
- Site-Specific Safety Plan for subcontractors in Texas$199
A Site-Specific Safety Plan is the written plan a subcontractor submits to the general contractor before mobilizing: scope, hazards, controls, competent persons, emergency plan, training, and site rules for one project.
- Fall Protection Plan for roofing, framing, and steel contractors in Texas$149
A Fall Protection Plan is the written program for work at height: the fall hazards on the project, the systems in use, anchor points, rescue, training, and, where conventional protection is infeasible, the plan a qualified person signs under 29 CFR 1926.502(k).
- Silica Exposure Control Plan for concrete, masonry, and demolition contractors in Texas$149
A written exposure control plan is required of every employer whose workers cut, drill, grind, or chip concrete, masonry, stone, or tile: the tasks, the Table 1 controls and respirators for each, housekeeping, access restriction, the competent person, and medical surveillance.
- Heat Illness Prevention Plan for outdoor and roofing contractors in Texas$149
A Heat Illness Prevention Plan is the written program for water, shade, rest, acclimatization, high-heat procedures, monitoring, emergency response, and training, for outdoor and indoor work in the heat.
- Hazard Communication Program for every trade in Texas$149
A Hazard Communication Program is the written program every employer with hazardous chemicals must have: the chemical inventory, labels, Safety Data Sheets, training, non-routine tasks, and how information is exchanged on a multi-employer site.
- Injury and Illness Prevention Program for California employers in Texas$149
An Injury and Illness Prevention Program is the written program every California employer must have under Title 8 3203: responsibility, compliance, communication, hazard identification, investigation, correction, training, and recordkeeping.
- Construction Fire Safety Plan (NFPA 241) for general and mechanical contractors in Texas$149
A Construction Fire Safety Plan is the fire prevention program for construction, alteration, and demolition work: the Fire Prevention Program Manager, hot work permits, temporary heating, fire protection impairments, site security, egress, housekeeping, and the emergency plan.
What Texas GCs raise first
- Federal OSHA standards apply to private construction; the state preempted local rest-break ordinances in 2023.
- Heat is the first thing a Texas GC's safety director asks about between May and September.