Site-Specific Safety Plan for subcontractors in Maryland.
A GC in Baltimore wants a Site-Specific Safety Plan that names this project, this crew, and this scope. That is what you get here, in Word and PDF, English and Spanish.
What GCs in Maryland check for
The GC's safety director checks it against the subcontract's safety exhibit before you can badge in: named competent persons with a basis, hazards matched to your scope, an emergency plan with the nearest hospital, a training and orientation section, and a signature page. A corporate manual does not pass; it has to name this project.
Maryland GCs, especially in Baltimore, review subcontractor plans before badging. The plan is built to pass that review the first time.
- MOSH enforces the state program with Maryland additions.
- Maryland adopted a heat stress standard in 2024 requiring a written plan at a heat index of 80 degrees.
Every section a reviewer looks for is fixed and written against ANSI A10.33 project structure, OSHA 1926 subparts by hazard, and the USACE A-02 reviewer checklist; your answers fill in the project, the hazards, the controls, and the names.
Competent persons, the nearest hospital, the muster point, and the emergency chain are all in it, because those are the lines a reviewer checks first.
What’s inside
- 1.Project information
- 2.Responsibilities
- 3.Competent persons
- 4.Hazard analysis by task
- 5.Fall protection
- 6.Electrical safety / LOTO
- 7.Silica and dust
- 8.Emergency action plan
- 9.Training and toolbox talks
- 10.Signatures
$199 for the document, with free edits and regeneration for 30 days and a full refund if the GC rejects it.
Questions from Maryland subs
- What do GCs in Maryland ask for in a site-specific safety plan?
- The same core elements across Baltimore and Washington suburbs: scope of work, a hazard analysis by task, controls for each hazard, named competent persons, an emergency plan with the nearest hospital, training and orientation, incident reporting, and a signed acceptance page. MOSH enforces the state program with Maryland additions.
- Is a corporate safety manual enough?
- Usually not. Subcontract safety exhibits ask for a plan written for this project: the project name, the GC, the scope, the site's hazards, and the people on this crew. That is what the plan generates.
- Does a site-specific safety plan have to be state-specific in Maryland?
- Maryland runs its own state plan, enforced by Maryland Occupational Safety and Health (MOSH), so the plan follows federal 1926 plus the state's additions. Your plan is written for the project address, and where Maryland has its own rule on the subject the plan says so and applies the stricter requirement.
- Is this OSHA-approved?
- No document is. OSHA and the state programs do not approve written plans; they inspect against them. This plan is prepared from your answers, says so on page one, and you adopt and implement it. That is what a GC's safety director is checking for.
- How long does it take?
- About 15 minutes of questions on your phone, then the documents generate in under two minutes. Word and PDF, English and Spanish, with your logo on the cover.
- What if the GC asks for changes?
- Edit your answers and regenerate as often as you like for 30 days at no charge. Every version stays downloadable. If it is not what you needed, reply to any of our emails within 30 days for a full refund.