Silica Exposure Control Plan for concrete, masonry, and demolition contractors in Wyoming.
Most safety directors in Cheyenne can tell a template from a plan in the first page. This Silica Exposure Control Plan is built from your scope, your hazards, and your people.
What GCs in Wyoming check for
GCs and OSHA inspectors ask for the written plan by name under 29 CFR 1926.1153(g). They look for each task matched to its Table 1 row, the competent person, the housekeeping rules (no dry sweeping or compressed air), and how you keep other trades out of the dust.
Because the project is in Wyoming, the plan's state section covers what Wyoming OSHA and local GCs ask about beyond the federal baseline.
- Wyoming OSHA enforces the state program, which adopts federal 1926 with Wyoming additions.
It reads like a plan a safety professional wrote for this job because the structure was written that way, against 29 CFR 1926.1153 and Table 1, before your answers went in.
The sample pages on this site are for a fictional electrical sub; your plan reads the same way with your project, your GC, and your crew.
What’s inside
- 1.Purpose and scope
- 2.Tasks involving respirable crystalline silica
- 3.Table 1 task mapping and engineering controls
- 4.Housekeeping methods
- 5.Restricted access and communication
- 6.Competent person
- 7.Medical surveillance and training
- 8.Signatures
It costs $149, takes about 15 minutes, and comes back in Word and PDF with a Spanish copy.
Questions from Wyoming concrete and masonry subs
- Who enforces the silica standard in Wyoming?
- Wyoming runs its own state plan, enforced by Wyoming OSHA, so the plan follows federal 1926 plus the state's additions. The respirable crystalline silica standard for construction applies either way, and the plan is written to 1926.1153(g).
- Do I need air monitoring?
- Not for tasks that match a Table 1 entry and follow its control fully. Tasks outside Table 1 need objective data or exposure monitoring; the plan has a section for those and tells you what it requires.
- Does a silica exposure control plan have to be state-specific in Wyoming?
- Wyoming runs its own state plan, enforced by Wyoming OSHA, so the plan follows federal 1926 plus the state's additions. Your plan is written for the project address, and where Wyoming has its own rule on the subject the plan says so and applies the stricter requirement.
- Is this OSHA-approved?
- No document is. OSHA and the state programs do not approve written plans; they inspect against them. This plan is prepared from your answers, says so on page one, and you adopt and implement it. That is what a GC's safety director is checking for.
- How long does it take?
- About 15 minutes of questions on your phone, then the documents generate in under two minutes. Word and PDF, English and Spanish, with your logo on the cover.
- What if the GC asks for changes?
- Edit your answers and regenerate as often as you like for 30 days at no charge. Every version stays downloadable. If it is not what you needed, reply to any of our emails within 30 days for a full refund.