Fall Protection Plan for roofing, framing, and steel contractors in Georgia.
Pre-mob paperwork due and the Fall Protection Plan is the one holding up the badge? Answer ten questions and it is written for the project, not copied from a template.
What GCs in Georgia check for
GCs on roofing, framing, steel, and precast scopes want to see which systems you use where, who the competent person is, how a suspended worker gets down, and the training record. If you plan to use warning lines or a safety monitor, they want the 502(k) reasoning in writing.
The plan is written for a Georgia project address, so the Georgia requirements a GC in Atlanta expects to see are included, not left for you to add.
- Federal OSHA standards apply to private construction.
- Large Atlanta GCs run their own orientation and site-specific plan reviews before badging.
Nothing in it is boilerplate you have to hunt through: the hazards come from your tasks and equipment, the controls from a library written to 29 CFR 1926 Subpart M (.500 to .503).
Nothing here is OSHA-approved, because nothing is. What you get is a plan that names the right people, matches the scope, and is signed by you.
What’s inside
- 1.Purpose and scope
- 2.Qualified and competent persons
- 3.Fall hazards identified for this project
- 4.Fall protection systems in use
- 5.Anchor points and equipment inspection
- 6.Infeasibility narrative (1926.502(k)), when selected
- 7.Rescue plan
- 8.Training
- 9.Signatures
$149 once. No account, no subscription, 30-day edits, 30-day refund.
Questions from Georgia roofing and framing subs
- What is the fall protection trigger height in Georgia?
- Federal OSHA requires fall protection at 6 feet above a lower level in construction, and Georgia follows that baseline. Your GC may require more, and the plan applies the stricter requirement.
- Do I need a qualified person?
- Only for engineered anchorages, horizontal lifelines, or a fall protection plan under 1926.502(k) where guardrails, nets, and harnesses are infeasible. The wizard asks; if you name one, the plan includes the signed 502(k) section.
- Does a fall protection plan have to be state-specific in Georgia?
- Private construction in Georgia is covered by federal OSHA (Federal OSHA (Atlanta area offices)). Your plan is written for the project address, and where Georgia has its own rule on the subject the plan says so and applies the stricter requirement.
- Is this OSHA-approved?
- No document is. OSHA and the state programs do not approve written plans; they inspect against them. This plan is prepared from your answers, says so on page one, and you adopt and implement it. That is what a GC's safety director is checking for.
- How long does it take?
- About 15 minutes of questions on your phone, then the documents generate in under two minutes. Word and PDF, English and Spanish, with your logo on the cover.
- What if the GC asks for changes?
- Edit your answers and regenerate as often as you like for 30 days at no charge. Every version stays downloadable. If it is not what you needed, reply to any of our emails within 30 days for a full refund.