Fall Protection Plan for roofing, framing, and steel contractors in Arkansas.
Roofing, framing, and steel contractors in Arkansas get asked for a Fall Protection Plan before the first day on site. This one is prepared from your answers in about 15 minutes.
What GCs in Arkansas check for
GCs on roofing, framing, steel, and precast scopes want to see which systems you use where, who the competent person is, how a suspended worker gets down, and the training record. If you plan to use warning lines or a safety monitor, they want the 502(k) reasoning in writing.
In Arkansas, Federal OSHA is the enforcing agency. Where the state has its own requirement on this subject, the plan carries a Arkansas section that says so.
- Federal OSHA standards apply to private construction.
It reads like a plan a safety professional wrote for this job because the structure was written that way, against 29 CFR 1926 Subpart M (.500 to .503), before your answers went in.
The sample pages on this site are for a fictional electrical sub; your plan reads the same way with your project, your GC, and your crew.
What’s inside
- 1.Purpose and scope
- 2.Qualified and competent persons
- 3.Fall hazards identified for this project
- 4.Fall protection systems in use
- 5.Anchor points and equipment inspection
- 6.Infeasibility narrative (1926.502(k)), when selected
- 7.Rescue plan
- 8.Training
- 9.Signatures
$149, ready in about two minutes after you answer, with your logo on every page.
Questions from Arkansas roofing and framing subs
- What is the fall protection trigger height in Arkansas?
- Federal OSHA requires fall protection at 6 feet above a lower level in construction, and Arkansas follows that baseline. Your GC may require more, and the plan applies the stricter requirement.
- Do I need a qualified person?
- Only for engineered anchorages, horizontal lifelines, or a fall protection plan under 1926.502(k) where guardrails, nets, and harnesses are infeasible. The wizard asks; if you name one, the plan includes the signed 502(k) section.
- Does a fall protection plan have to be state-specific in Arkansas?
- Private construction in Arkansas is covered by federal OSHA (Federal OSHA (Little Rock area office)). Your plan is written for the project address, and where Arkansas has its own rule on the subject the plan says so and applies the stricter requirement.
- Is this OSHA-approved?
- No document is. OSHA and the state programs do not approve written plans; they inspect against them. This plan is prepared from your answers, says so on page one, and you adopt and implement it. That is what a GC's safety director is checking for.
- How long does it take?
- About 15 minutes of questions on your phone, then the documents generate in under two minutes. Word and PDF, English and Spanish, with your logo on the cover.
- What if the GC asks for changes?
- Edit your answers and regenerate as often as you like for 30 days at no charge. Every version stays downloadable. If it is not what you needed, reply to any of our emails within 30 days for a full refund.